French Wire Finish

French Wire

Professional finish for hand-strung beads

French wire, also know as gimp, gimp wire, or bullion wire will give your hand strung beads and precious gemstones a professional finish as well prolongs it safety by decreasing wear and tear on the stringing threads. Our full article on French wire also gives a simple way of using this finely coiled gimp wire.

The technique below gives another and a more detailed step-by-step guide. Be sure to take note of the Tips below.

Tools Needed

• strung beads, pearls, or gemstones
• gimp or french/bullion wire
• silk or other stringing threads
• crimp beads (french crimps)
• crimping pliers

Steps

1) After you have strung your beads, pass the one end of your thread through a crimp bead and a suitable length of French wire/gimp.  Then through the ring of your clasp. Do not try to pass the thread twice through the gimp. If you do the gimp wire will not form properly and you could end up with a mess.
2) Pass the thread back through the crimp bead and pull tightly.  The gimp should now look like a metal loop going through your clasp-ring. 3) (opt) Pass the thread through more beads for security. 4) Squeeze the crimp beads with crimping pliers to secure and fix the threads.  Cut off excess threading.
5) Do the same with the other side of your strung beads.